Amcor HEPA TOWER plus 사용 설명서 - 페이지 7

{카테고리_이름} Amcor HEPA TOWER plus에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amcor HEPA TOWER plus 10 페이지.

It is recommended that the pre-filter is cleaned every 8 weeks.

To clean the pre-filter, follow these steps:

1. Face the air intake grill.

2. Press on the centre and release the filter cover (fig. 4).

3. Detach pre-filter sheet from the retaining strips on all corners (fig. 5).

4. Shake dust out of pre-filter sheet.

You can wash the pre-filter sheet in mild detergent, rinse, and air-dry thoroughly. (Do

not place in automatic dryer).

5. Re-attach the pre-filter sheet to retaining corner (fig. 5).

6. Replace filter cove^ bottom edge first, and snap in place (fig. 6).

7. The pre-filter sheet must be replaced when damaged.

REPLACING THE HEPA FILTER UNIT

It is recommended to replace the HERA filter unit once a year or earlier depending on the

accumulated dirt, see "Filter condition indicator" (fig. 8).

When it is time to change the filter, follow the steps below:

1. Purchase a new HERA filter unit from your retailer.

(The replacement filter assembly contains both a new washable pre-filter and HEPA

filter).

2. Face the air intake grill.

3. Press on the centre and release the filter cover (fig. 4).

4. Lift filter cover off and set aside.

5. Remove the entire HERA filter unit (fig. 7). Dispose of entire old HERA filter unit

including pre-filter.

6. Install new HERA filter unit by inserting bottom edge first and align in place.

7. Replace filter cover; bottom edge first, and snap into place (fig. 6).