Floe VSD 6000 조립 지침 매뉴얼 - 페이지 8
{카테고리_이름} Floe VSD 6000에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD 6000 12 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD 6000에 대해서도 마찬가지입니다: 조립 설명서 (12 페이지), 조립 지침 매뉴얼 (8 페이지), 조립 지침 매뉴얼 (16 페이지)
페이지 인쇄
ST EP 4
The 109" ball screw tube is attached using the
pre-installed clamps on the corner posts. Orient
the tube so the large grease hole is on the side
facing out. Pull the cable out the other end so
there are no kinks in the cable.
Hoist the tube up and insert the end of the ball
screw into the hole in corner post. Insert the
cable from the other end in the corner post slot
and over the pulley.
Attach the cable end of the tube using (2) 3/ 8" x
6" bolts and (2) 3/ 8" nylock nuts. The ball screw
end is attached using a 3/ 8" x 6" bolt and 3/ 8"
nylock nut in the top hole. Do not fasten a bolt
in the bottom hole at this time.
3/ 8" x 6 1/ 2" bolt
and 3/ 8" nylock nut
Ball screw tube
Grease Hole
Corner post clamps
3/ 8" x 5 1/ 2" bolt
and 3/ 8" nylock nut
SHEET 8 OF 12