Floe VSD6500 조립 지침 매뉴얼 - 페이지 4
{카테고리_이름} Floe VSD6500에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD6500 8 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD6500에 대해서도 마찬가지입니다: 조립 지침 (12 페이지), 조립 지침 매뉴얼 (16 페이지)
페이지 인쇄
INSTALLATION
RAISE END OF LIFT WITH A HIGH LIFT JACK (OR EQUIVALENT) THAT WILL HAVE THE LEG EXTENSIONS
INSTALLED ON. FOR SMALL LIFTS, RAISE FRAME BEAM 44" ABOVE THE GROUND (FIGURE 1.1). FOR
LARGE LIFTS, RAISE FRAME BEAM 38" ABOVE THE GROUND (FIGURE 1.1A). REMOVE ½" NYLOCK NUT
AND ½" BOLT ON EACH SANDPAD, THEN REMOVE SAND PADS (FIGURE 1.2).
FIGURE 1.1
IMPORTANT NOTE
FOR INSTALLATION OF LEG
EXTENSIONS, THE LIFT MUST BE RAISED
ON ONE END (BOTH IF INSTALLING
TWO KITS). BE SURE TO PROPERLY
SUPPORT THE LIFT TO AVOID TIPOVER,
FIGURE 1.1A
2X
FIGURE 1.2
SHEET 4 OF 8