Floe P-1600 조립 지침 매뉴얼 - 페이지 12
{카테고리_이름} Floe P-1600에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe P-1600 12 페이지. Anchoring system
Floe P-1600에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (7 페이지)
페이지 인쇄IF ADDITIONAL ADJUSTMENT IS REQUIRED, LOOSEN 3/8" NUTS AND SLIDE POCKETS
ON FRAME BEAM WITH ANCHOR ASSEMBLIES UNTIL DESIRED POSITION IS FOUND.
ONCE POSITION IS SET, RE-TORQUE NUTS TO 35 FT-LBS (FIGURE 2.9).
DRIVE ANCHOR ASSEMBLY INTO LAKE BOTTOM USING 1-1/8" 6 POINT SOCKET & 1/2" DRIVE
RATCHET UNTIL COLLAR TOUCHES TOP OF ANCHOR POCKET (FIGURE 2.10).
IMPORTANT NOTE:
ONLY USE A 6
POINT SOCKET.
12 POINT SOCKETS
MAY CAUSE
DAMAGE TO HEX
SHAFT.
6 POINT SOCKET
12 POINT SOCKET
DO NOT USE
2X
FIGURE 2.10
SHEET 12 OF 12
IMPORTANT
IMPACT OR
CORDLESS
ANCHORS.
2X
FIGURE 2.9
DO NOT
USE AN
DRILL TO
INSTALL
LIFT