Floe VSD6500 조립 지침 매뉴얼 - 페이지 16

{카테고리_이름} Floe VSD6500에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD6500 16 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD6500에 대해서도 마찬가지입니다: 조립 지침 (12 페이지), 조립 지침 매뉴얼 (8 페이지)

페이지 인쇄
Floe VSD6500 조립 지침 매뉴얼
FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5).
-THE WIDTH OF THE BUNKS SHOULD KEEP THE PONTOONS OFF THE CRADLE BEAMS.
-THE BUNKS SHOULD BE KEPT AS LOW AS POSSIBLE (NOT QUITE TOUCHING THE CLAMP).
-TO PLACE BUNKS, FIND CENTER BETWEEN PONTOONS AND CENTER OF THE BOAT FROM PONTOONS
AND TRANSLATE MEASUREMENT TO CRADLE BEAM TO DETERMINE CENTER OF EACH PAIR OF BUNKS.
LOCATE MIDDLE BUNKS AROUND CENTER OF CRADLE BEAM.
-THE REAR OF A 21' PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY
ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES
BEYOND THE REAR OF THE LIFT. THESE ARE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN
INDIVIDUAL'S CIRCUMSTANCES.
-ONCE BUNKS ARE IN THEIR FINAL LOCATION, TORQUE 3/8" NUTS ON CRADLE CLAMPS TO 35 FT-LBS
AND 5/8" NUTS ON CRADLE CLAMPS TO 70 FT-LBS (FIGURE 2.5).
FIGURE 2.5
SHEET 16 OF 16