Floe VSD 6000 조립 설명서 - 페이지 8

{카테고리_이름} Floe VSD 6000에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD 6000 12 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD 6000에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (12 페이지), 조립 지침 매뉴얼 (8 페이지), 조립 지침 매뉴얼 (16 페이지)

페이지 인쇄
Floe VSD 6000 조립 설명서
FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5A & 2.5B).
-THE WIDTH OF THE BUNKS SHOULD BE 1-2 INCHES LESS THAN THE DISTANCE BETWEEN THE
PONTOONS.
-TO SET BUNK HEIGHT, MEASURE FROM THE BOTTOM OF THE PONTOON DECK TO THE BOTTOM OF
THE PONTOON, THEN ADD 1" TO THAT MEASUREMENT.
-THE REAR OF A 21 FOOT PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY
ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES
BEYOND THE REAR OF THE LIFT.
THESE ARE THE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN INDIVIDUAL'S
CIRCUMSTANCES.
ONCE FINAL POSITION IS SET, TORQUE 3/8" NUTS ON CLAMPS TO 35 FT-LBS (FIGURE 2.6).
FIGURE
2.5A
UPRIGHTS MAY HAVE TO BE CUT TO
ALLOW FULL TRAVEL OF CRADLE ONCE
FINAL PLACEMENT IS ESTABLISHED.
NOTE:
SHEET 8 OF 12