FLOJET 20465010 매뉴얼 - 페이지 3

{카테고리_이름} FLOJET 20465010에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FLOJET 20465010 8 페이지. Bottled water system

페이지 인쇄

Select a cabinet large enough to accommodate the 5 gallon (19L) bottle and suction wand assembly. Place the

pump module on the floor of the cabinet with on/off switch and suction tube facing out toward the cabinet doors.

Position as close as possible to a

grounded electrical outlet and

place the five gallon bottle close to

the pump module without kinking the

suction hose.

Push clip up to lock

Insert float sensor switch plug/connector into pump

module "SWITCH" port.

The connections for the float and power supply

will require moderate force to insert fully. This

is a design feature that assures the connections

are held securely after initial installation. MAKE

SURE PLUG / CONNECTOR IS INSERTED ALL THE

WAY INTO THE CONNECTIONS. FAILURE TO

INSERT FULLY WILL LEAD TO POOR OPERATION

OR NO OPERATION.

PLUMBING INSTALLATION

PLUMBING

To install tube into

"OUT" port. Push

1/4" discharge

tubing all the way

into quick

connect port

(as far as it will go)

Insert suction hose port

fitting into pump module

"IN" port and slide locking

port clip in place.

Insert DC plug/connector into pump module "DC IN" port.

The connections for the float and power supply will require

moderate force to insert fully. This is a design feature

that assures the connections are held securely after initial

installation. MAKE SURE PLUG / CONNECTOR IS INSERTED

ALL THE WAY INTO THE CONNECTIONS. FAILURE TO

INSERT FULLY WILL LEAD TO POOR OPERATION OR NO

OPERATION.

The Bottled Water Dispensing System may

also be placed in a pantry, closet, cellar or

other location where a grounded electrical

outlet is available.

To remove tube from "OUT" port:

Push tube all the way in

Hold gray ring against black

port with finger or flat tool

Pull tube out