FLOJET Bottled Water Dispenser Plus 설치 및 유지 관리 지침 매뉴얼 - 페이지 2

{카테고리_이름} FLOJET Bottled Water Dispenser Plus에 대한 설치 및 유지 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FLOJET Bottled Water Dispenser Plus 17 페이지.

The FLOJET Bottled Water Dispensing System was designed to pump purified water from a commercially available

5-gallon purified water bottle. The system will deliver the water under pressure to an individual drinking water faucet,

the water inlet of a refrigerator for the icemaker and chilled drinking water tap, and to certain commercial coffee / tea

brewers.

When the suction wand is inserted into the standard 5-gallon bottle, it will activate the float switch on the end of the

wand and turn on the pump. This same float switch shuts off the system when the bottle is empty. The wand has a

built in back-flow preventor valve that prevents water in the system from flowing back into the bottle, or spilling while

changing bottles.

The heart of the system is the pump module that automatically adjusts the flow and pressure to fill an appliance or

faucet, and stops automatically.

The system is equipped with an automatic thermal cut-off device for additional protection.

A. Pump Module with On/Off Rocker Switch, 3.5 ft. (1m) Cord.

B. Suction Wand and Hose Assembly

C. 20 ft (6.1m) of 1/4 in. (6.35mm) Discharge Tube

D. Kit Fitting: Hose port/connector,

compresion nut

and sleeve.

E. Wall power transformer.

1. Medium sized Wrench

2. 7/16 in. (11.12mm) or

1/2 in. (12.7mm) Drill Bit

3. Power Drill

4. Sharp Knife or Box Knife

HOW THE SYSTEM WORKS