ACR STOVES MAL2MF 기술 매뉴얼 - 페이지 5

{카테고리_이름} ACR STOVES MAL2MF에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES MAL2MF 17 페이지. Multifuel stove

페이지 인쇄

Location of the unit

Clearances to non-

combustible materials

There is a recommended minimum

clearance of 150mm at each side of the

appliance. A clearance of 150mm is

required at the back of stove (if the rear

wall has a thickness of 200mm or more

this measurement can be reduced to

50mm) a recommended clearance of

300mm is required above the appliance

for servicing purposes.

Clearances to combustible

materials

There must be a minimum clearance of

550mm at each side and 450mm at the

rear of the appliance from any

combustible materials. If using single

wall flue pipe, there must be a clearance

of at least 3 times the diameter of the

flue pipe (e.g. 125mm diameter pipe =

375mm minimum clearance) from any

combustible materials e.g. wooden

beam.

Curtains and soft furnishings should be

a minimum of 1m away from the

appliance.

Adequate space should be provided for

servicing the appliance.

We do not recommend that televisions

or artwork are positioned above the

appliance.

Please remember that this appliance

has been designed to provide heat and

if installed into a recess enough space

should be left around the appliance to

enable the heat produced to rise and

escape from the recess back into the

room.

Installation Instructions

Hearth Requirements

The appliance must stand on a level

fireproof hearth with a minimum

thickness of 12mm. The hearth

temperature created by this stove is

below 100˚C. The hearth must protrude

at least 225mm in front of the appliance

and 150mm either side of the appliance.

The appliance shall be installed on a

floor with an adequate load bearing

capacity. If an existing construction

doesn't meet with prerequisite, suitable

measures (e.g. load distributing plate)

shall be taken to achieve it.

Flue Requirements

The chimney must comply with current

Building Regulations. Provision must be

made to provide access for cleaning the

appliance, the flue gas connector and

the chimney flue.

The flue must be:

In sound condition and provide

sufficient draft (minimum 12pa)

Suitable for use with solid fuel burning

appliances

Be able to clean the entire length of the

flue system without removal of the

appliance

Free from deposits

Well insulated

At least 4m in height

The flue must not be:

Shared with other appliances

Weight bearing on the appliance

A smaller diameter than the appliance

flue collar size (125mm)