ACR STOVES Rowandale FB3MF 기술 매뉴얼 - 페이지 6

{카테고리_이름} ACR STOVES Rowandale FB3MF에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES Rowandale FB3MF 10 페이지. Multifuel cast iron stove

페이지 인쇄

Troubleshooting

Problem

Probable Cause

Fire difficult to

• Green wood / wet wood

start / goes out

• Logs are too large

• Not enough primary air

• Insufficient draft

Fire burns too quickly

• Too much draft

• Excessive draft

Smokes on initial

• Flue is cold

lighting

Smokes while burning

• Insufficient draught

Low heat output

• Poor quality wood

Maintenance

We recommend that the appliance is serviced annually by a competent

engineer to ensure it's continued safe operation.

The chimney should be swept at least

once a year together with the flue pipe

connection. Care should be taken to

ensure that there is not a build up of

soot on the baffle and in the airways of

the appliance.

If the appliance has not been operated

for long periods, the flue should be

inspected and swept before use to

ensure there are no blockages within the

flue.

The grate should be cleaned regularly

and the ashpan emptied daily.

Never allow the ash in the ashpan to

overfill allowing ash to be in contact

with the underside of the grate.

Action Recommend

Use hardwood logs with a maximum

moisture content of 20%

Use kindling and small logs to start the

fire and once established use split logs

Open air control

Check the flue is not obstructed

Reduce the air control

Install a draft stabiliser

Burn paper and kindling to increase

heat in flue

Check the flue is not obstructed

Use seasoned Hardwood (this has a

Higher calorific value)

This will overheat the grate and cause

premature wear and distortion.

• The internal vermiculite panels of the

appliance should be checked regularly

for soundness. If any wear and tear is

found, we recommend these parts are

replaced immediately.

• Check the rope door seals are intact

and are not worn. These should be

replaced on an annual basis to ensure

the correct operation of this appliance.

• The glass can be cleaned using a soft

damp cloth or a ceramic glass cleaner

(available from your local stockist)

Use only replacement parts

recommended by the manufacturer.

To remove the internal vermiculite baffle:

Firstly remove the front fuel retaining

bars.

Then slightly lift the baffle and ease one

of the side bricks forward by pulling the

front edge of the side brick into the

Commissioning Check List

Please tick boxes when each procedure is completed

Ensure the serial number has been recorded on the front of this manual for any

future use

Ensure the door seals are in good condition and that the glass is secured correctly

in the door (do not over tighten the glass as this will prohibit its expansion and

could cause the glass to crack)

Ensure that all internal components are fitted correctly (these may have shifted in

transit)

Ensure that the appliance operates correctly during the first firing

Ensure the customer is aware that fumes may be given off during the first firings

as the paint cures

Advise the customer on the safe operation of the appliance

Leave the instruction manuals, operating tool and glove for the customer's use.

Record the flue draught reading of the appliance

combustion chamber. Remove the

second side brick in the same manner,

the flue baffle can now be removed by

lowering the front edge and rotating the

baffle and removing through the front

door.