Flomec QSI 제품 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Flomec QSI에 대한 제품 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Flomec QSI 16 페이지. Cover plate transmitter for g2 meters
페이지 인쇄QSI3 WIRING
Figure 6
Customer Equipment with Built-in Power Supply
Inputs: Standard Remote Sensor (Variable Reluctance Pickup Coil)
Outputs: Customer Equipment, 4-20mA Sensing, Built-in Loop Power Supply
CAUTION: When reassembling the cover plate, make sure the enclosure seal is not crimped or twisted.
Do not over-tighten screws (hand-tighten only).
Figure 7
QSI VERSION 3 – PC BOARD
4-20mA
QSI VERSION 3 - WIRING DIAGRAM
9
Minimum signal amplitude required for
normal operation is approximately 15mV P-
P. Recommended cable type - twisted pair
with shield. Recommended maximum cable
length - 20ft.