ACR STOVES FB5BK 기술 매뉴얼 - 페이지 5

{카테고리_이름} ACR STOVES FB5BK에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES FB5BK 10 페이지.

페이지 인쇄

Installing the appliance

Install the top canopy support above

the door on the internal face of the

appliance using the pre-drilled holes

and bolts supplied.

Insert bolts here

Install the two top/side support

brackets, remove the nut on the

upper left and right side on the

casting and insert the support

bracket onto the bolt, retighten nut

Install the two lower/side support

brackets, remove the nut on the

upper left and right side on the

casting and insert the support

bracket onto the bolt, retighten nut

Affix side/rear cover using the 4 bolts

provided to the top and lower

support brackets.

Install the unit into the desired

position and make the flue

connection using the 150mm flue

adaptor supplied

20mm

Install the canopy onto the top

support bracket and position the

canopy ensuring that there is a

minimum 20mm air gap between the

rear of the canopy and the non-

combustible wall, once in position

drill and self-tap the underside of the

canopy through the top support

bracket

Operating your stove

Please note that during the first firing, we recommend a small fire is lit

and that you slowly increase the temperature to enable the various

parts to expand normally.

• You may also experience fumes and a

haze being given off by the stove

during the first firing and possibly for

the next couple of firings as the paint

cures. This is normal, but please

ensure that the room is well ventilated

during this period.

• The appliance should not be operated

in mild weather with smokeless fuel.

Under certain weather circumstances

e.g. fog the chimney will not draw

sufficiently and could cause

asphyxiation. Either await better

weather conditions or burn wood only.

• In the rare event of a malfunction due

to overheating or a chimney fire, the

air slides should be shut down

completely and the fuel allowed to

burn out. In the event of a chimney

fire, once the air slides have been

closed

Recommended Fuels

Wood: hardwood such as ash, oak and

beech which have been cut for at least 2

Always check with your dealer or directly with the manufacturer as using the

incorrect fuel may invalidate your guarantee and damage your appliance.

Using your appliance for the

first time

• To allow the appliance to bed in, and

fixing glues and paint to fully cure,

only fire the appliance using kindling

and just get hot for at least three fires.

• Before lighting the next small fire

years and stored under shelter. The logs

should have a maximum moisture

content of 20%. Maximum log length

250mm, maximum width 125mm.

Prohibited Fuels

Green wood: i.e wood which is less

than 2 years old with a moisture content

of above 20%

Recovered wood: i.e pallets, railway

sleepers etc. These will have been

chemically treated and will pollute the

atmosphere and possibly overheat the

appliance.

Housecoal or Bituminous coal: these

fuels will soot up the airways of the

stove and possibly overheat the

appliance.

Petroleum Based Coke: over 20%

content - this will overheat the appliance

and possibly damage the unit.

Liquid fuels.

Paraffin fire lighter blocks..

please allow the appliance to return

back to room temperature.

• During these first small fires you may

experience a haze and unpleasant

smell as the paint cures, do not touch

the paint and keep the room well

ventilated.