AMD DIrect SSRFR-24DK2 사용자 설명서 - 페이지 7

{카테고리_이름} AMD DIrect SSRFR-24DK2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMD DIrect SSRFR-24DK2 9 페이지.

페이지 인쇄

INSTALLATION

REPLACE ALL PANELS BEFORE OPERATING

This appliance should be properly grounded for your

safety. The power cord of this appliance is equipped

with a three-prong plug which mates with a standard

three-prong wall outlet to minimize the possibility of

electrical shock.

Do not under any circumstance cut or remove the

third (ground) prong from the power cord supplied.

For personal safety, this appliance must be properly

grounded. Any questions concerning power and/

or grounding should be directed toward a certified

electrician or an authorized service center.

The appliance requires a standard 115/220 Volt AC-

60HZ three-prong grounded electrical outlet. Have

the wall outlet and circuit checked by a qualified

electrician to make sure the outlet is properly

grounded. When a standard 2-prong wall outlet is

encountered, it is your responsibility and obligation

to have it replaced with a properly grounded 3-prong

wall outlet.

To prevent accidental injury, the cord should be

secured behind the appliance and not left exposed

dangling.

The appliance should always be plugged into

its own individual electrical outlet which has a

voltage rating that matches the rating label on the

appliance. This provides the best performance and

also prevents overloading house wiring circuits that

could cause a fire hazard from overheating. Never

unplug the appliance by pulling on the power cord,

always grip the plug firmly and pull straight out from

the receptacle. Repair or replace immediately all

power cords that have become frayed or otherwise

damaged. Do not use a cord that shows cracks

or abrasion damage along its length or at either

end. When moving the appliance, be careful not to

damage the power cord.

WARNING

Improper use of the grounded plug can result

in the risk of electrical shock. If the power

record is cord is damaged, have it replaced by a

qualified or an authorized service dealer.

KEGERATOR USER MANUAL

EXTENSION CORD

Because of potential safety hazards under certain

conditions, it is strongly recommended that you

do not use an extension cord with this appliance.

However, if you must use an extension cord it is

absolutely necessary that it be a UL/CUL-Listed,

3-wire grounding type appliance extension cord

having a ground type plug and outlet and that the

electrical rating of the cord be 115 volts and at least

1.3 amperes.

INSTALLING THE STAINLESS STEEL HANDLE

This appliance includes a stainless-steel handle that

is not required to operate this unit. To install the

handle please follow the below instructions:

1. Pull away the door gasket in the area where the

handle is to be installed as shown in illustration.

The gasket is easily displaced by hand, no tools

are necessary.

2. Locate the screws included in the bag with the

user's guide. Insert the screws into the holes as

shown.

3. Align the handle with the screws installed.

Tighten the screws using a Phillips head

screwdriver until the handle sets both flush and

secured tightly against the door frame. (DO NOT

overtighten as this will cause damage to the

handle assembly).

4. Replace the door gasket to its original Position.