Aero Mist 50 Series 시작 지침

{카테고리_이름} Aero Mist 50 Series에 대한 시작 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aero Mist 50 Series 1 페이지. Aero mist, inc. water pump instruction manual

AERO MIST

1. Remove cover (4) screws

2. Remove red plug in crank case and install yellow oil dipstick provided before

starting unit. Oil level should be ½ full on glass. Unit is pre-filled with oil.

3. DO NOT EXCEED 1000 PSI OPERATING PRESSURE. The pressure is

adjustable by using a 7/8" hex socket located next to the pressure gauge.

4. Mount on a level surface, such as a concrete pad.

5. After inlet filter is installed, flush lines before installing ½" inlet hose to lock

hose barb. No hose clamps are required. Push hose up to the yellow washer.

6. Install ¼" high pressure hose to ¼" NPT pipe on pump.

7. Flush lines before inserting nozzles.

8. Hand tighten nozzles (do not over tighten; do not tighten nozzles when system

is pressurized.

9. CHANGE PUMP OIL EVERY 500 HOURS OF USE(or every other year)

Use 30 wt non detergent oil.

10. DO NOT RUN PUMP WITH OUT WATER

Note: Install 20 amp dedicated outlet for pump. Full load amps on 50100, 50150,

50200 pumps will range from 12.0 – 15.0 amps

For replacement parts please contact:

Aero Mist, Inc.

23610 N 20

Dr #6

Phoenix, AZ 85085

Office: 623-444-5121

Fax: 623-879-8901

50 SERIES PUMP START UP INSTRUCTIONS