AME Intl. 14455 사용 설명서 - 페이지 2

{카테고리_이름} AME Intl. 14455에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AME Intl. 14455 6 페이지. Premium air hydraulic bottle jack

14455 INSTRUCTION MANUAL

FAILURE TO READ THESE WARNINGS MAY RESULT IN PROPERTY

Support load by appropriate means after lifting. Use as lifting device only. Do not exceed rated

capacity. Use only on hard level surface. Center load on the jack. DO NOT MODIFY JACK. Only

MODEL

LIFTING

CAPACITY

14455

20 TON

It is the owner/operator responsibility to properly use and maintain this equipment and the legibility of all

warnings and instruction labels. Carefully read and understand the instructions and warnings in this

manual before operating this equipment. Keep this manual in a safe location for future reference.

Warranty of this unit will be void on any part if the unit subjected to misuse due to overloading, abuse,

is your responsibility to be aware of existing Federal, State and Local codes and regulations governing the

safe use and maintenance of this unit.

Prior to each use, visually inspect for leaking hydraulic oil, damaged, loose or missing parts. If jack is

worn or damaged remove from service and contact your nearest service center for repair.

Check oil level. With the jack in an upright position and the ram completely retracted, open the release

necessary with clean hydraulic jack oil.

Lubricate internal components. With the release valve open, manually pump the handle six times.

Purge the hydraulic system of air. During transit the unit may become "air-bound", causing a spongy ram

action. To purge the system, close the release valve (turn clockwise). Manually pump the jack to full height.

Open the release valve and push down on the ram. Repeat these steps if necessary to completely purge

the system.

Keep the jack clean. Occasionally lubricate the handle socket pivot point, extension screw, release screw

thread, and air valve to prevent corrosion.

AME INTERNATIONAL

!WARNING!

DAMAGE AND OR PERSONAL INJURY.

vehicle designated by the vehicle manufacturer.

MIN.

1ST STAGE

HEIGHT

245 MM

475 MM

NET

GROSS

WEIGHT

16 KG

18 KG

PACKAGE

AIR

SIZE

PRESSURE

31x24x31

0.7-1.0 MPa