CO2 Meter CM-1650 빠른 시작 매뉴얼

{카테고리_이름} CO2 Meter CM-1650에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CO2 Meter CM-1650 2 페이지. Portable co2 welding gas analyzer
CO2 Meter CM-1650에 대해서도 마찬가지입니다: 운영 매뉴얼 (15 페이지)

페이지 인쇄
CO2 Meter CM-1650 빠른 시작 매뉴얼
Inlet Port
Outlet Port
1.
Unpack the device, ensure it is charged
and ready to use.
2.
Power on and wait for the device to
complete it's warm up cycle.
3.
Use the included tubing and flow
regulator to connect your CM-1650
to your gas source. Please note, the
tubing should be connected to the
inlet port (right hand side). Ensure
the regulator is in the fully open
position (1.0 LPM).
*Failure to use the included regulator could
result in serious damage to the device.*
QUICK
START
GUIDE:
CM-1650
PORTABLE CO2
WELDING GAS
ANALYZER
4.
Use the up and down directional buttons
to scroll through mixture options and
select your CO2 blend to be analyzed,
then press Enter.
5.
Connect your flow regulator to the
source, open the regulator fully to
apply gas to activate the device.
Secure your tubing and you are ready
to begin analyzing.
Watch Our Quick Start Video Here