CO2 Meter RAD-0002-ZR 사용자 설명서 및 설치 설명서 - 페이지 14
{카테고리_이름} CO2 Meter RAD-0002-ZR에 대한 사용자 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CO2 Meter RAD-0002-ZR 18 페이지. Oxygen o2 deficiency safety alarm
CO2 Meter RAD-0002-ZR에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)
페이지 인쇄
Calibration
1. Flow certified 21% Oxygen calibration gas into the sensor port on the front of
the monitor. Wait 3-5 minutes before starting calibration, then execute the
"SPAn" calibration.
(Continue to flow calibration gas through entire process)
2. Press Mode until CALI is flashing in small print under the O2 reading.
3. Press Enter to view the calibration settings.
4. "SPAn" and "O2" will be flashing.
5. Press Enter again to begin the calibration. "CALIBRATING" will begin flashing.
(Continue to flow calibration gas throughout eFntire process)
6. After approximately 3 minutes, the display either "PASS" or "FAIL".
7. If "PASS" press enter to save.
8. If "FAIL" repeat the process.
9. If "FAIL" more than twice, contact CO2Meter technical support.
14 | P a g e
R A D - 0 0 0 2 - Z R / M a n u a l a n d I n s t a l l a t i o n
G u i d e