ACR STOVES VitaMax 사용자 설명서 - 페이지 8
{카테고리_이름} ACR STOVES VitaMax에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES VitaMax 12 페이지. Outdoor oven range
페이지 인쇄
VitaMax
Remove all of the parts from the crate
■
and all of the parts that are contained
within the pizza oven dome.
It may be easier to put the pizza dome
■
on it's back for this part, place a blanket
down first, just make sure that the dome
is nice and stable and that you aren't
damaging any of the nice paintwork.
Locate the rear leg, it's the one with the
■
wheel attached, there are two rear legs
make sure that the correct leg is fitted
to the correct side! The wheel should be
on the inside of the leg, facing towards
the front of the oven.
Align the rear leg on the inside of the
■
metal pizza dome frame, line up the
holes and connect using four M5 x
12mm screws and the four M5 nuts,
tighten using a suitable screwdriver and
an 8mm spanner.
Next connect the other rear leg in the
■
same manner as above.
Position the storage shelf between the
■
two rear legs, line up the holes and
attach using one M5 x 12mm screw per
leg.
Position the front leg on the inside of
■
the metal pizza dome frame, line up the
holes and connect using four M5 x
12mm screws and the four M5 nuts,
tighten using a suitable screwdriver and
an 8mm spanner.
Next connect the other front leg in the
■
same manner as above.
Line up the holes in the storage shelf
■
and attach using one M5 x 12mm screw
per leg.
Sit the pizza oven dome on it's legs, be
■
careful it's heavy! Don't forget to use a
friend.
Check that the legs are square to the
■
pizza dome, check and retighten any of
the screws and nuts as necessary.
Slide the preparation shelves onto the
■
two hooks located on the left and right
of the pizza dome body and firmly push
into place.
il Padre
Attach the chimney base starter section
■
to the corresponding flue hole on the
top of the pizza dome, secure the
square base plate to the dome using
the four M5 x 12mm screws provided.
Slip the chimney top section over the
■
starter section and make sure that it's
fully located down.
Replace the insulating firebricks (the
■
lightweight ones) as shown below:
Vermiculite insulating firebricks
• 4 x (25 x 108 x 570mm) No1
Replace the chamotte firebricks (the
■
heavy ones) on top of the insulating
firebricks, as shown below:
Chamotte firebricks
• 4 x (30 x 220 x 300mm) No1
• 2 x (30 x 92 x 220mm) No2
• 2 x (30 x 240 x 300mm) No3
• 1 x (30 x 214 x 300mm) No4
Place your VitaMax oven onto a
■
suitable, level surface, a sufficient
distance away from anything flammable,
as detailed above.
Place the pizza dome door onto the
■
front shelf.
■
Let's get cooking!!