CO2 Meter RAD-0002-ZR 매뉴얼 - 페이지 2
{카테고리_이름} CO2 Meter RAD-0002-ZR에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CO2 Meter RAD-0002-ZR 7 페이지. Oxygen o2 deficiency safety alarm
CO2 Meter RAD-0002-ZR에 대해서도 마찬가지입니다: 사용자 설명서 및 설치 설명서 (18 페이지)
페이지 인쇄
Installation Steps
1. Choose a suitable location near a wall outlet to install the SEU.
2. To install the SEU (Sensor Unit) start by making a mark about 12
inches off the floor or at eye level depending on the application.
3. Screw the mounting bracket into the wall where you placed your
mark. If you are using the wall adapter, mount the sensor unit close
to a wall outlet. (Make sure it is mounted in an area that it will not
accidentally get hit by boxes or heavy machinery).
4. Attach one end of the ethernet cable to the SEU (Sensor Unit), then
slide the Sensor Unit onto the mounted bracket on the wall. 5. Plug
in the wall adapter – the SEU (Sensor Unit) should automatically
turn on and perform a self-check.
6. Securely attach the safety strap over the power supply, to ensure it
does not become accidentally unplugged.
7. The Green light should appear and show that the SEU (Sensor Unit)
has power.
8. Over the next few minutes, all lights will flash, and resort back to green.
This means the O2 level matches the ambient O2 level in the room and
provides you with a precise, accurate percent O2 reading.
Next, the Small Remote Display Install
1. Make a mark for the RDU (Remote Display Unit) outside the room where the
SEU is and CO2 is stored. Screw the mounting bracket where the mark is.
(Should be mounted at eye level.)
a. Plug in the other end of the ethernet cable into the back of the RDU
(Remote
Display Unit)
b. Mount the RDU onto the bracket on the wall, the input on the Remote
Display Unit should be connected to the output on the SEU (Sensor Unit).
c. Place the warning signs that came with the device on the wall directly next
to the RDU. (The signs should be visible).
Please ask CO2 Meter specialist for clarification.