10Bar 10BAR 450D 사용자 설명서 - 페이지 7

{카테고리_이름} 10Bar 10BAR 450D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10Bar 10BAR 450D 9 페이지. Canon camera accessories user manual

5. Use & Care of Housing:

5.1 Pre Dive Function Check.

Just before entering the water, make a habit of reviewing the proper steps to close the housing and

connect the bulkhead. Make a visual check of the O-ring seal. It is also useful to switch on the camera,

and check that controls e.g. on/off, zoom, shutter functions operate normally.

Check housing is closed

Check O-ring is in the groove between housing and Acrylic

Check battery and memory card status on the LCD display

Check control knob and zoom function

Check the Bulkhead is properly connected or blanked.

Always avoid submerging the housing in hot water for a prolonged time or a cleansing tank where

the water may be heated up by the sun.

5.2 General Operation.

The control levers and push buttons consist of internal double O-ring seals on a

arrangement is very reliable, however as a precaution, when

movements, as this may distort the O-ring. Also please allow for the fact that the camera takes a few

seconds to power on. If the camera does not appear to respond to a control action, make sure that no other

controls are pressing on the camera, i.e. locking out further actions.

Wear the wrist strap; it is easy to inadvertently let go of the housing, especially if you are distracted.

5.3 Cleaning & Storage.

The body & lid of the housing are made of 6061 Aluminum and Acrylic respectively. 6061 Aluminum is

selected for its outstanding strength stiffness, hardness and toughness, While Acrylic for its crystal clear

transparency and high gloss surface. Both of them have good resistance to weathering, although

long-term exposure to sunlight should be avoided. Normal operating temperature range is 3°C to 36°C

(Storage temperature: -10°C to 50°C)

It is good practice to rinse off your housing with fresh water after every dive. Avoid to exposure to fine

sand. After a series of 10 or more dives, e.g. after a dive holiday, it is recommended to immerse the

housing for 2-3 hours in warm water to dissolve any salt deposits that may have built up. No chemical

cleaners should be used.

Important!!!

For long term storage please remove the main closure o-rings from body.

operating the controls, avoid excessively rapid

stainless steel shaft. This