Co2meter GasLab SAN-103 사용자 설명서 - 페이지 2

{카테고리_이름} Co2meter GasLab SAN-103에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Co2meter GasLab SAN-103 7 페이지. Micro formaldehyde monitor

Please take a moment to read these instructions before use. They will provide you with

all the necessary information for the correct use of your formaldehyde monitor.

Theory of Operation

The SAN-103 Formaldehyde Monitor uses an electrochemical sensor to determine the

concentration of formaldehyde in air samples. Air reaches the sensor by diffusing through the

openings on the side of the unit. Normal air movement is enough to carry the sample to the

sensor.

Device

1. OLED display

2. Power button

3. Units switching button

4. Alarm LED

5. Micro USB charge port

6. Vent

7. Clip

8. Silicone boot

OLED Display

1. Formaldehyde concentration

2. Air Temperature (°F or °C)

3. % Relative Humidity

4. Concentration unit in ppm or mg/m3

5. Battery Charge Indicator

OPERATION

Plug the USB cable into the meter and a 120VAC wall adapter. It will take approximately 2

hours to receive a full charge. Once the meter is charged, it can run 10+ days before

recharging.

Press the power button to turn on the meter.

When the meter is first turned on, it performs a 10 second countdown for device warm up, then

enters normal display with the current formaldehyde level displayed. The device starts taking

measurements when powered on and updates readings every 3 seconds.

The OLED display will turn off automatically after 120 seconds of inactivity to conserve battery

power. However, the sensor will continue to monitor the CO level. Briefly press the Power

button to view the display.

PAGE 2 of 7