Amedia vStar DMA3000T 사용자 설명서 - 페이지 5

{카테고리_이름} Amedia vStar DMA3000T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amedia vStar DMA3000T 6 페이지. Digital media adaptor

Amedia HK Ltd.

3.2

Connect the AV Receiver to an A/V Display

Step 5: Connect one end of the A/V cable (RCA or S-Video) to the audio (2F, 2G), and video (2H for

RCA and 2J for S-video) output jacks, and connect the other end of the A/V cable to the

display device via its "AV input ".

Step 6: Keep the IR window oriented toward front when using your source device's remote

controller.

Step 7: Power on the AV Receiver by connecting the DC plug of the Power Adapter to the DC jack

(2K), and connect the power supply to an outlet.

Step 8: The Power on LED (2A) shall be on, the Link LED (2B) shall start blinking.

Step 9: The Link LED (2B) shall stop blinking and stay in solid in less than 5 minutes. By then, the

wireless link is successfully established.

After plug the power, the Power on LED (1A or 2A) is not on?

Check the power outlet and make sure the power is on. Then unplug the DC supply from the DC

jack (1K or 2K) and plug it back on. Repeat this a few times if problem persists.

During the setup, what if the Link LED (1B or 2B) keeps blinking and doesn't turn solid on?

This indicates the wireless link is not up yet. Check both AV Sender and AV Receiver to make sure

they are both power on. If the problem still persists, do following steps:

Step 10: Go to the AV Sender. Press (and release) the Paring button (1E). The Pairing LED (1C)

shall be on.

Step 11: Go to the AV Receiver. Press (and release) the Paring button (2E). The Pairing LED

(2C) shall be on. It shall quickly go off after the Link LED (2B) stop blinking and stay

solid on.

Note: the Pairing LED will go off in 45 seconds if there is no wireless link.

If the Link LED continues blinking after Step 10 and 11, you may have to move the AV Receiver

closer to the AV Sender and try the setup again.

After the wireless link established, what if the AV Receiver's Link LED (2A) changes from

solid on to blinking or even off?

This indicates the loss of the wireless link. If the link cannot recover in 5 minutes, reset the power of

the AV Receiver.

Wireless Multimedia Connectivity Solutions