AMENA HCV-B Series 운영 매뉴얼 - 페이지 14
{카테고리_이름} AMENA HCV-B Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMENA HCV-B Series 16 페이지.
페이지 인쇄
Troubleshooting
Phenomenon
The unit can not run.
Coolin(Heating) e ciency is not good.
Wireless remote control is not available.
If water leakage in the room.
If water leakage in outdoor unit.
Noise from indoor unit emitted.
reak o
Troubleshooting
Has the power been shut down?
Does power plug come loose from the socket?
Is the circuit protection device tripped o or not?
Is voltage higher or lower?
(Tested by professionals)
Is the Timer correctly used?
Is Temp. setting suitable?
Were inlet and outlet vents obstructed?
Is there too much dusts accumulated and
obstructed the lter?
Are the windows and doors closed?
Did Fan speed set at low speed?
Is there any heat sources in the room?
The unit is interfered by abnormal or frequent
functions switchover occasionally the controller
cannot operate. At this time, you need to pull
out of the plug, and reinsert it.
Is it in its receiving range? Or obstructed?
To check the voltage in wireless remote control
inside is charged, otherwise to replace the
batteries.
Whether the wireless remote control is damaged.
The air humidity is on the high side.
Condensing water over owed.
The connection position of indoor unit drainage
pipe is loosed.
When the unit is running in COOL mode, the
pipe and connection of pipe would be condensed
due to the water cooled down.
When the unit is running in Auto Defrosting mode,
the ice thawed and owed out.
When the unit is running in HEAT mode, the
water adhered on heat exchanger dripped o .
The sound of fan or compressor relay is switching
on or o .
When the defrosting is started or stop running,
it will sound. hat is due to the refrigerant owed
to the reverse direction.