ACR STOVES E1200 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} ACR STOVES E1200에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR STOVES E1200 9 페이지. Electric fireplace insert range

페이지 인쇄

Product Technical Information

Model E600

Supplier Name

ACR HEAT PRODUCTS LTD

Model Number

E600

Voltage

220V-240V AC50HZ

Fuse

13 Amp

Minimum Heat Output

800 Watts

Maximum Heat Output

1600 Watts

Product Dimensions

H 650mm • W 678mm • D 168mm

Model E900

Supplier Name

ACR HEAT PRODUCTS LTD

Model Number

E900

Voltage

220V-240V AC50HZ

Fuse

13 Amp

Minimum Heat Output

800 Watts

Maximum Heat Output

1600 Watts

Product Dimensions

H 600mm • W 978mm • D 168mm

Model E1200

Supplier Name

ACR HEAT PRODUCTS LTD

Model Number

E1200

Voltage

220V-240V AC50HZ

Fuse

13 Amp

Minimum Heat Output

1000 Watts

Maximum Heat Output

2000 Watts

Product Dimensions

H 617mm • W 1192mm • D 348mm

678mm

168mm

978mm

168mm

1152mm

1192mm

348mm

Controls

Manual Controls

• The appliance can be operated manually

using the controls situated on the top right

hand side of the insert.

• On/off power switch – this is used to turn

the mains supply to the appliance on or off.

When the switch is in the ON position, the

orange stand by indicator light will show on

the top right corner of the screen. This switch

needs to be in the ON position to operate

manually or via the remote control / app.

• STAND BY - Used to switch the appliance to

Standby Mode

Remote Control

Please note batteries are not included. 2 x AAA batteries are required.

• FLAME - Pressing this button will allow you

to cycle through the 4 flame settings

• HEATER - Press this once to select low heat

(the indicator light will glow orange), twice to

select the high heat (the indicator light will

glow red), three times to switch the heater off.

The heater will blow cold air for a number of

seconds once switched off before coming to

a stop. Please note that the heater will only

operate when the room temperature is below

the temperature indicated on the remote

control handset. This can be altered via the

handset or via the app.

• MODE - This allows the appliance to go

through a pre-programmed sequence of

effects. To use this, press and hold the MODE

button until it beeps (approx 4 seconds) and

the selection of pre-programmed sequences

will commence.

• Remove the battery/control panel

cover by sliding completely down

and insert 2 x AAA batteries

ensuring these are inserted

correctly. Slide the cover back up to

the original position to refit. Old

batteries should be disposed of

responsibly at a local recycling

location.

• Ensure that the ON/OFF power

switch on the unit is in the ON

position.

• Aim the remote control handset

directly towards the fire and press

the function button required.

• Sliding the door down on the

remote control will reveal more

functions. Otherwise using the

basic remote control buttons will

operate the fire in the same way as

the manual control buttons.