Coalbrookdale GS1i 설치 및 서비스 지침 - 페이지 5

{카테고리_이름} Coalbrookdale GS1i에 대한 설치 및 서비스 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Coalbrookdale GS1i 19 페이지.

GAS CONNECTION

The complete installation must be tested for soundness

and purged as described in BS. 6891.

The gas inlet to the stove is 8mm dia compression, and

providing the distance from the service cock to the stove

does not exceed 1.5m, 8mm dia rigid or semi-rigid supply

pipe may be used.

Above this length, 15mm dia rigid or semi-rigid pipe

should be used.

A service cock must be fitted adjacent to this appliance.

Unpacking

Remove all parts from inside the pack and ensure that no

damage has occurred during delivery transit. If so, please

contact your local stockist.

Items in Pack:

Instructions-Installation/Servicing and Operating

Coal Guard

Small Coals (9)

Large Coals (14)

Control Cover

Door Locking Tool

Clay Aggregate

Fixing Screws and Rawlplugs

Proceed to assemble the stove as follows:

If the reduced leg position is required. Gently lay the

stove on its side. Unscrew the front legs secured with

one screw. Refit in second hold further back with screw

previously removed.

CLOSURE PLATE

The closure plate must always be fitted as in Fig. 1C with

the four rawlplugs, screws and decorative caps supplied.

Adhesive tape or other sealing material which is suitable

for the type of surface may be used. (The closure plate

supplied with the stove may be cut, on site, to the correct

size depending upon the size of the fireplace opening).

Locate the stove so that the flue spigot protrudes at least

20mm into the chimney cavity.

Position the appliance in accordance with the instruction

given in the section 'LOCATION' and connect the flue

pipe in accordance with the section 'THE FLUE'.

FLEXIBLE PIPE/CONNECTIONS MUST NOT BE USED.

Connect the stove to the gas supply. (See Gas

Connection).