Coalesse Lagunitas 매뉴얼 - 페이지 2

{카테고리_이름} Coalesse Lagunitas에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coalesse Lagunitas 3 페이지. Corner screen replacement
Coalesse Lagunitas에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

페이지 인쇄

Screen removal is best done with the unit laying on its

back. To prevent the unit from getting dirty, lay down a clean

piece of cardboard or plastic and then place the unit onto its

back.

Remove two (2) flat head bolts at the front of the bench.

Remove two (2) socket head bolts from the rear attachment

bracket as shown.

NOTE: Make sure to have a person supporting the screen,

so it doesn't fall over. At this point the screen is only held in

place with a panel clip. Failure to support the screen will

damage this clip.

With the bolts removed, the screen will be loose, but is

still joined to the adjacent screen with a screen ganging clip

roughly 4 inches down from the top of the screen. To remove

this clip, insert a pair of needle nose pliers between the

screens and compress the clip. With the clip compressed,

you should be able to pull the screens apart.

NOTE: If the screens don't release, try to push

the screens together while compressing the

panel clip. This will remove any tension on the

clip and you should be able to pull the screens apart.

NOTE: If you don't have a pair of needle nose pliers, a flat

head screwdriver can be used to push down on the clip to

release it.

SCREEN

GANGING CLIP

FLAT HEAD BOLT

SOCKET HEAD BOLT

Page 2 of 3

902507401 Rev A