Coast to Coast Mr. Wolf 매뉴얼 - 페이지 9
{카테고리_이름} Coast to Coast Mr. Wolf에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coast to Coast Mr. Wolf 10 페이지.
페이지 인쇄
Trouble Shotting
Coins can't be
inserted in.
It doesn't work after
inserting the coins
Tickets come out
continually.
Tickets can't come out.
No sound.
The machines can't
record points.
The head of some
Wolf doesn't work.
All wolves' heads
can't move.
The whole machine
doesn't work.
Reasons
1."+12v"power supply isn't connected.
2.The coin-insert device hasn't been
adjusted well.
1. The electronic coin-insertadvice is out
of the order.
2. The purple or yellow wire isn't incontact.
1. The ticket dispenser is out oforder that
it can't send the feedback-pulse to the
main PCB board.
2. The feedback-pulse of the
the main PCB board are not in contact
1.Reset the toggle switch, but the
machine must be reset, too.
2.Drivng signal on the motherboard isn't
sent out.
3.Damage of ticket dispenser.
1.The loudspeaker is out of order.
2.The TDA1519C is out of order.
3. No sound,and no display.
"
1.
The photo switch
TCRT5000
"
"
9014 scoring points is out of order.
2.The circuit isn't in contact.
1.
The corresponding electromagnetism
valve is out of order.
"
2.The corresponding
of order.
3.The head is jammed by mechanism trouble.
"
"
1.The
AC18
power supply hasn't
been in contact.
"
"
2.The IN5408
burns out.
1.The power supply hasn't been connected.
2.The power supply box is out of order.
3. 89C52 is out of order.
1.Inspect circuit
2.Replace coin
1.Replace the electronic coin-insert advice.
2.Inspect the circuit.
1. Replace the ticket dispenser witha new one.
2. Inspect the circuit.
Greenwire and
1.Reset the toggle switch, and the machine must
be reset, too.
2.Inspect the white wire. When tickets need not
to come out, it is low level, while it must be high
level when tickets come out. Otherwise the
wires haven't been in contact.
3.Clear the ticket dispenser or replace it.
1.Test the loudspeaker, and replace it if the
circuit is opened.
2.Touch the POT with your hand. If there is
no buzz the "TDA1915C"is out of order.
You have to replace it with a new one.
3.Check the whether the "+12"power supply
has been supplied to the "TDA1519C".
"
for
1.Replace the "TCRT500"or
2.Inspect the circuit.
1.Replace the electromagnetism value with
a new one.
"
TIP122
is out
2.Replace the TIP122
3.Readjust the machine.
1.Check that whether the transformer works
normally.
2.Replace the IN5408 .
1.Inspect the "AC220v" power supply.
2.The power supply box has no "+5v" or
"+12v" output. Replace it.
3.Replace the corresponding 89C52.
6
Solutions
"
9014
"
"
with a new one.
"
"
"
.