Coast to Coast WF2AU1B 운영 매뉴얼 - 페이지 10
{카테고리_이름} Coast to Coast WF2AU1B에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coast to Coast WF2AU1B 16 페이지. Long-range, high-performance cellular wifi extender
페이지 인쇄WINEGARD
CONNECT
®
STATUS SCREEN MESSAGES:
Connected to WiFi XXXX
Scanning
Trying to Connect to WiFi XXXX
Logging into WiFi XXXX
Bad Password
Not Connected
Connecting to WiFi XXXX
9
2.0 SUPPORT cont.
™
The Winegard ConnecT 2.0 unit is communicating with the source WiFi signal and working. If you
are unable to connect to the internet, the source signal may have a problem.
The Winegard ConnecT 2.0 unit is looking for WiFi signals in range. This can take a few minutes.
Once the unit is able to identify all of the signals, they will be listed and you will be able to
choose one.
You have selected a source signal and the Winegard ConnecT 2.0 unit is attempting to connect to
this source. Once connected, the message should change to "Connect to..."
The source signal is password protected. This message will be displayed after you have entered
the correct password and the two systems work out the security protocols.
The source signal is password protected. This message will be displayed after you have entered an
incorrect password and the source system has rejected the connection. Generally this screen will
only be seen if the source signal is distant or weak. Normally, the password will be rejected on the
network password screen.
The Winegard ConnecT 2.0 system is not connected to a network.
The Winegard ConnecT 2.0 system is communicating to the selected source signal and a
connection is being made. This will generally only take a minute or two.