Coast-Air CEW061BS 설치 및 작동 지침 매뉴얼 - 페이지 6
{카테고리_이름} Coast-Air CEW061BS에 대한 설치 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coast-Air CEW061BS 16 페이지.
Installation and Operation Instruction Manual
INSTALLATION INSTRUCTIONS
1
PREPARE THE WINDOW
Lower sash must open sufficiently to allow a clear
vertical opening (H) of following size (see Table 1).
Side louvers and the rear of the AC must have clear
air space to allow enough airflow through the
condenser,for heat removal. The rear of the unit must
be outdoors, not inside a building or garage.
Mounting Hardware
3/4 (or 1/
2
)
Lock Frame
Screws
(2)
(7)
NOET: Weather stripping is only for Energy star
models.
2
PREPARE AIR CONDITIONER
A: Remove the air conditioner from the carton and
place on a flat surface.
B:
Remove top rail and R1 hardware (R1 hardware
only for Energy star models) from the packaging
material as shown in Fig. A.
Top Rail Hardware
3/8 Screws
(4)
Packaging
Top Rail
www.coastair-ac.com
Window sash
Weather
Sash Lock
seal foam
stripping
(1)
(1)
(10 *3/4 *1/12 )
(5)
Top Rail
R1 hardware
(2)
(1)
Fig.A
R1 hardware
(for <
10000
Btu/h models
only
)
R1 hardware(for
>
10000Btu/h models
only
)
C: Align the hole in the top rail with those in the top
of the unit as shown in Fig.B
D: Secure the top rail to the unit with the 3/8 Screws
as shown in Fig.C.
NOTE: For safety reasons, all four(4) screws MUST
be securely fastened.
NOTE: The top rail hardware and the Fig.A,
Fig.B and Fig.C are not applicable to the units
more than 10000Btu/h.Before installing unit,
the top rail must be assembled on the unit (For
<10000Btu/h models only).
3
INSTALL THE ACCORDION PANELS
NOTE: Top rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of (5/16 ).
This is necessary for proper condensed water
utilization and drainage. If you are not using the Side
Panels for any reason, this pitch to the rear must be
maintained.
Fig.1
5
5
6,000 - 12,000
Fig.B
Fig.C
A.Place unit on floor, a bench or
a table. Hold the Accordion
Panel in one hand and gently
pull back the center to free the
open end. See Fig.1