Coastal WEATHERPAK MTR 사용자 설명서 - 페이지 8

{카테고리_이름} Coastal WEATHERPAK MTR에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Coastal WEATHERPAK MTR 20 페이지.

2-2

SYSTEM ASSEMBLY

2-2.1

Receiver/Display Connections

The WEATHERPAK

MTR Receiver/Display box contains the radio receiver and features a 5.7" color TFT display with a

touch screen. In addition, it contains GPS and electronics that allow the WEATHERPAK

computer. The touch screen on the display provides access to multiple screens that display the weather data in a variety

of ways, including: Active, Preview, and Weatherpak Status screens, a columnar list of other WEATHERPAK

vicinity, and sensor data graphs.

Connect the external GPS and radio antenna to the appropriate connectors on the back of Receiver/Display

box. (See Figure 2).

Connect the USB data cable. (The Ethernet connection will only be used in rare instances where the

Receiver/Display box will be connected to a network).

Plug the Receiver/Display box power supply AC cord into a power source (110V, unless otherwise marked) then

plug the mini-plug end into the plug on the back of the Receiver/Display box.

Press the green power "On/Off" button on the front of the unit. The power indicator light will illuminate, the

Coastal Environmental Systems splash screen will immediately appear, and the display will complete its boot-up

within 20-30 seconds.

2-2.2

Connecting to a Computer with Serial Port (used on earlier MTR versions)

Plug one end of the Serial data cable into the Serial connector (RS 232) on the back of the Receiver/Display box

and the other end into an available 9-pin Serial port on your PC.

Turn the Receiver/Display on.

The receiver power indicator light should now be on. The system will take approximately 20-30 seconds to boot-

up.

With the WEATHERPAK

up routine, the amber colored data light will blink approximately every 30 seconds as an indication that data is

being received from the WEATHERPAK

P/N: 0302-140-001 Rev. D

Figure 2 - Back of Receiver/Display Box



assembled and running and after the Receiver/Display box has completed the boot-

WEATHERPAK

User's Manual

to communicate with the

s in the

MTR