10Bar FL 50 - Hot-shoe clip-on Flash 사용자 설명서 - 페이지 4

{카테고리_이름} 10Bar FL 50 - Hot-shoe clip-on Flash에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10Bar FL 50 - Hot-shoe clip-on Flash 11 페이지. Camera housing

4.3 Opening levers:

After unscrewing and pulling out the pressure release plug, the lid can be opened. To

overcome the friction of opening, use lever (Fig. 2) to push against the lid with a cam action.

Be sure they are inserted all the way flat to the housing before turning to avoid damaging the

protrusions on the lid. The body has four holes on each corner edges for opening. Gently

lever off the lid with the supplied lever (Fig. 3) taking care not to twist the lid excessively.

The lid should be opened keeping it approximately paralleled to the body at all times, turn

first one corner a little, then the other a little, and repeat again until the lid is opened.

Remember to unscrew and pull out the pressure release plug all the way first, otherwise the

air pressure will resist attempts at opening. Lay the lid on a flat stable surface after opening.

(Fig. 2)

4.4 Special note on responsibility for watertight integrity:

Each housing is individually inspected and hydrostatically tested in the factory. The

design of the main piston O-ring seal is among the most reliable in the industry and the

watertight integrity is excellent. This special O-ring design provides a perfect seal even if

there is any movement between the body and lid due to change of ambient pressure.

However please note that responsibility for ensuring the integrity of the watertight seal lies

entirely with the user. 10 BAR accepts no liability for damage to, or loss of any equipment

used with, or placed inside the housing. Users are highly recommended to carry out in-water

test of the housings without installing of the camera for their first dive after change of new

ports or alternation of any new configuration. The test can be carried out by lowering the

housing with ballast to the working depth or dive down to the safe diving range.

The O -ring seal is the only barrier between the water outside and the air

space within the camera. It is an effective barrier only if the seal is properly

maintained. The O-ring seal should be inspected before every dive. The following

information is provided for your guidance in using and maintaining the O-ring seal.

(Fig. 3)

8/6/2006