10Bar FL 50 - Hot-shoe clip-on Flash 사용자 설명서 - 페이지 7

{카테고리_이름} 10Bar FL 50 - Hot-shoe clip-on Flash에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10Bar FL 50 - Hot-shoe clip-on Flash 11 페이지. Camera housing

(Fig. 7)

Screw home the pressure release plug (Fig. 7). There is no need to excessively tighten

this plug. The seal is made by internal O-rings. The O-ring on the underside of the plug is just

to keep out dirt.

After replacing the lid, make a final visual inspection of the main O-ring for

contamination (Fig. 8)

(Fig. 8)

Note: If the O-ring is in good contact, a thin black line, about 0.5-1mm in width

should be visible, where the O-ring is in contact with the lid. Follow this line all

the way round the edge of the seal, as a final check that the seal is good.

The housing is now ready for the dive.

Important !!!

pushed back inside and then screwed home, do not over tighten this

plug (finger tight only).

Before diving, make sure the pressure release plug is

8/6/2006