aero pure ABF110DCMH-SG6 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} aero pure ABF110DCMH-SG6에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aero pure ABF110DCMH-SG6 15 페이지. Bath fan
aero pure ABF110DCMH-SG6에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (15 페이지)

페이지 인쇄
aero pure ABF110DCMH-SG6 설치 지침 매뉴얼
PLUG-IN DEVICES
Humidity(RH%)
CO
2
INSTALLATION PLUG-IN DEVICES
Humidity Sensor Module or Motion Sensor Module is included with this fan.
Contact Aero Pure to purchase CO2 Sensor Module.
Position A is for CO
2
and position C is for Motion Sensor module.
1. Fix to the specified devices to the slot, till hear the sound installed in place.
2. Access USB interface, insert the connector of module into USB receptacle.
B
A
Notes:
Suitable for use with solid-state speed controls.
Solid-state speed controls may cause harmonic
distortion which can cause motor humming noise.
6
Humidity Sensor Module- Included in this Aero Pure fan. Insert module
into USB interface. The fan automatically turns on or boosts to a higher
speed when the Relative Humidity (RH) exceeds the user-adjustable
set-point. The fan automatically runs in a lower speed after a period of
time delay or stops running when the Relative Humidity falls below the
set-point.
Humidity detection value setting range: 30% - 80%
Motion Sensor Module- Insert model into USB interface. The fan runs
or boosts to high speed when motion sensor begins to detect.
The fan runs in low speed after a period of time delay or stops working
when you are out of detection range.
Motion Sensor detection range as below,
CO2 Sensor Module- Insert module into USB interface. The module
begins to detect environmental CO2 concentration when fan is on for
2 minutes, then the fan starts to run or boosts to high speed when
concentration level is over 1000PPM. The fan runs in low speed after
a period of time delay or stops working when concentration level
is less than 800PPM.
Sensor module, position B is for Humidity Sensor module,
USB receptacle
The distance that motion can be
detected is limited to 10 feet (3m).
The field of view of the sensor is
90°. (Room temperature is 25℃).
C