aero pure ABF110DHG5SN 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} aero pure ABF110DHG5SN에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aero pure ABF110DHG5SN 15 페이지. Bath fan

PLUG-IN DEVICES

Humidity(RH%)

INSTALLATION PLUG-IN DEVICES

Humidity Sensor Module is included with this fan.

Contact Aero Pure to purchase CO2 Sensor Module.

Position A is for CO

1. Fix to the specified devices to the slot, till hear the sound installed in place.

2. Access USB interface, insert the connector of module into USB receptacle.

Notes:

Suitable for use with solid-state speed controls.

Solid-state speed controls may cause harmonic

distortion which can cause motor humming noise.

Humidity Sensor Module- Included in this Aero Pure fan. Insert module

into USB interface. The fan automatically turns on or boosts to a higher

speed when the Relative Humidity (RH) exceeds the user-adjustable

set-point. The fan automatically runs in a lower speed after a period of

time delay or stops running when the Relative Humidity falls below the

set-point.

Humidity detection value setting range: 30% - 80%

CO2 Sensor Module- Insert module into USB interface. The module

begins to detect environmental CO2 concentration when fan is on for

2 minutes, then the fan starts to run or boosts to high speed when

concentration level is over 1000PPM. The fan runs in low speed after

a period of time delay or stops working when concentration level

is less than 800PPM.

Sensor module, position B is for Humidity Sensor module.

USB receptacle