Aktakom ATE-6008 사용자 설명서 - 페이지 6

{카테고리_이름} Aktakom ATE-6008에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ATE-6008 7 페이지. Contact/non-contact tachometer

* RPM: Non-Contact revolutions per minute

measurements.

* rpm: Contact revolutions per minute measurements.

* HZ : Non-Contact /Contact frequency measurements.

* M/M: Contact Meter per minute measurements.

* I/M: Contact Inch per minute measurements.

* F/M : Contact Feet per minute measurements.

* Y/M: Contact Yard per minute measurements.

* REV: Revolution measurements.

* M : Length measurements in the uit of meter.(Using the

master 10cm circumference wheel.)

* In : Length measurements in the uit of inch. (Using the

master 10cm circumference wheel.)

* FT : Length measurements in the uit of feet. (Using the

master 10cm circumference wheel.)

* Yd : Length measurements in the uit of yard. (Using the

master 10cm circumference wheel.)

5 MEASURING CONSIDDERTATION

*Reflective mark

Cut and adhesive tap provide into approx 12mm (0.5 )

squares and apply one square to each rotation shaft.

a. The non-reflective area must always be greater than

the reflective area.

b. If the shaft is normally reflective, it must be covered

with black tape or black paint before attaching

reflective tape

c. Shaft surface must be clean and smooth before

applying reflective tape.

*VERY LOW RPM MEASUREMENT