Canon 9319A008AA 서비스 매뉴얼 - 페이지 7
{카테고리_이름} Canon 9319A008AA에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon 9319A008AA 22 페이지. Service manual
페이지 인쇄
4. SERVICE MODE
To conduct the following functions, a host computer (Windows 98 / ME / 2000 / XP), printer driver and
service tool (QY9-0066) for the iP1500 are needed.
Function
Print head manual cleaning
<For reference>
Print head deep cleaning
Paper feed roller cleaning
Test printing
1) Nozzle check pattern printing
<For reference>
Print head alignment
2) Shipment pattern printing
- ROM version
- Number of pages fed
- Waste ink amount
EEPROM reset
(Reset of waste ink counter etc.)
Destination setting
EEPROM information check
1
*
Shipment inspection pattern printing
a. Install the print head (QY6-0054-000), and press the Power button to turn on the printer. (The LED lights in green.)
b. Load A4-sized paper.
c. Connect the printer to the computer. Using the iP1500 service tool (QY9-0066), select "USB PORT." (See APPENDIX
2, ip1500 SERVICE TOOL.)
d. Select "TEST PATTERN 1." The printer starts printing the shipment inspection pattern.
2
*
Shipment inspection pattern sample
EEPROM contents can be confirmed from the shipment inspection pattern printout (top of the shipment inspection
pattern). See APPENDIX 1, SHIPMENT INSPECTION PATTERN 1, for print sample.
3
*
EEPROM reset / Destination setting
a. Install the print head (QY6-0054-000), and press the Power button to turn on the printer. (The LED lights in green.)
b. Connect the printer to the computer. Using the iP1500 service tool (QY9-0066), select "USB PORT". (See APPENDIX
2, iP1500 SERVICE TOOL.)
c. <Destination setting>
Destination can be set by clicking each model name in "SET DESTINATION."
Confirm the model name by clicking "GET DEVICE ID" after setting change. (If incorrect, it can be changed before
turning the unit OFF/ON.)
<EEPROM reset>
When "EEPROM CLEAR" is checked, the EEPROM is reset after the shipment inspection pattern printing.
Procedure
Select "Cleaning" from the printer driver's Maintenance.
Select "Deep Cleaning" from the printer driver's
Maintenance.
1. Remove the paper from the ASF.
2. Select "Roller Cleaning" from the printer driver's
Maintenance.
3. Following the instruction from the Status Monitor, load
3 sheets of plain paper in the ASF, and feed them.
Select "Nozzle Check" from the printer driver's
Maintenance.
1. Select "Print Head Alignment" from the printer driver's
Maintenance.
2. Select the optimal value using the printed head
position adjustment pattern.
Refer to Shipment inspection pattern*
Refer to EEPROM reset / Destination setting*
Refer to EEPROM reset / Destination setting*
Refer to Shipment inspection pattern*
( 7 / 21 )
Cleaning time: Approx. 40 sec.
Cleaning time: Approx. 70 sec.
Cleaning time: Approx. 2 min.
Nozzle check pattern printing
Significant misalignment can be
adjusted.
1
below.
Refer to Shipment inspection
pattern sample*
Host computer and service tool
are required.
3
below.
Host computer and service tool
are required.
3
below.
Host computer and service tool
are required.
1
below.
Host computer and service tool
are required.
Remarks
2
below.