Aktakom ATK-2001 사용자 설명서 - 페이지 4

{카테고리_이름} Aktakom ATK-2001에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ATK-2001 11 페이지. Clamp meter

2. Panel Description

1. Transformer Jaw

This is used to pick up current signal. To measure DC/AC current, conductor must

be enclosed by the jaw.

2. Transformer Trigger

This is used to open the jaw.

3. Function Selector and On/Off Switch

This is used to select the function user desired, such as DCA, ACA, DCV, ACV.

4. Data Hold Button

Once this button is pushed, reading shall be held on the LCD. Press again to release

it.

5. Max/Min Hold Button

This button is used to enable the maximum or minimum value to be displayed and

updated during measurement. Press once, minimum value shall be displayed and

updated. Press again, maximum value shall be displayed and updated. Zero

function will be disabled if MAX/MIN is enabled.

6. Zero/Relative Button

Once this button is pressed, the current reading shall be set to zero and be used as

a zero reference value for all other subsequent measurement. The function is also

used to remove offset value caused by the residual magetism remained in the core