Aero-motive RB210 서비스 매뉴얼 - 페이지 3

{카테고리_이름} Aero-motive RB210에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aero-motive RB210 4 페이지. Retractors

UNIT POWER SPRING TENSION ADJUSTMENT

READ INSTRUCTIONS BEFORE USE To avoid injury: all operators should be instructed in

CAUTION:

the safe, proper use and maintenance of this product.

CABLE CAN RETURN SUDDENLY

WARNING:

attached to retractor before adjusting tension.

CAUTION:

Do NOT Over-Tension balancer main spring. This will reduce cable travel and spring life.

Before making spring tension adjustments please check the following:



Tool and all accessories are attached to lower tool clip.



If tool attached to retractor cable descends, there is not enough tension on retractor mainspring.



If cable stop is tight up against cable guide, there is too much tension on retractor main spring.

Unit Tension Adjustment



To increase tension, turn Tension Knob (on the front of the retractor) clockwise or in the "+" direction until

desired tension is achieved – See FIG. 06.



Make sure Tension Knob has engaged back the ratchet teeth on front case before releasing Tension Knob.



To decrease tension, pull Tension Knob out such as to disengage from ratchet teeth on front of case and

turn counter-clockwise or in the "-" direction until pre-load is relieved from cable stop – See FIG. 06.



Make sure Tension Knob has engaged back the ratchet teeth on front case before releasing Tension Knob.

SM1110-06

To avoid serious injury or death: Load MUST be fully

FIG. 06

Page 3 of 4

REV - C