Acer AL1917W C 서비스 매뉴얼 - 페이지 4

{카테고리_이름} Acer AL1917W C에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AL1917W C 44 페이지. 19-inch flat panel active-matrix tft lcd
Acer AL1917W C에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (11 페이지), 매뉴얼 (12 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

Acer

Chapter 1- PRECAUTIONS & SAFETY NOTICES

1. SAFETY PRECAUTIONS

This monitor is manufactured and tested on a ground principle that a user's safety comes first.

However, improper used or installation may cause damage to the monitor as well as to the user.

WARNINGS:

This monitor should be operated only at the correct power sources indicated on the label on the rear

of the monitor. If you're unsure of the power supply in you residence, consult your local dealer or

Power Company.

Do not try to repair the monitor by yourself, as it contains no user-serviceable parts. This monitor

should only be repaired by a qualified technician.

Do not remove the monitor cabinet. There are high-voltage parts inside that may cause electric

shock to human bodies.

Stop using the monitor if the cabinet is damaged. Have it checked by a service technician.

Put your monitor only in a lean, cool, dry environment. If it gets wet, unplug the power cable

immediately and consult your closed dealer.

Always unplug the monitor before cleaning it. Clean the cabinet with a clean, dry cloth. Apply

non-ammonia based cleaner onto the cloth, not directly onto the class screen.

Do not place heavy objects on the monitor or power cord.

2. PRODUCT SAFETY NOTICE

Many electrical and mechanical parts in this chassis have special safety visual inspections and the

protection afforded by them cannot necessarily be obtained by using replacement components rated

for higher voltage, wattage, etc. Before replacing any of these components read the parts list in this

manual carefully. The use of substitute replacement parts, which do not have the same safety

characteristics as specified in the parts list, may create shock, fire, or other hazards.

3. SERVICE NOTES

When replacing parts or circuit boards, clamp the lead wires around terminals before soldering.

Keep wires away from high voltage, high temperature components and sharp edges.

Keep wires in their original position so as to reduce interference.

Adjustment of this product please refers to the user' manual.

Service Manual