Aktakom ATH-2261 사용자 설명서 - 페이지 10

{카테고리_이름} Aktakom ATH-2261에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ATH-2261 15 페이지.

1. Connect the power supply to the power source.

2. Press the POWER SWITCH [1] to turn on the power supply.

3. To setting CH1, use the CH1 VOLTAGE TUNE KNOB [18] to adjust CH1 voltage to give a desired output

voltage.

4. Connect the circuit to the TERMINALS [24,25]

5. Press AUTO CURRENT CUT OFF PROTECTION KEY [8] to activate output and the OUTPUT INDICATOR

[9] will on.

6. When the CH1 CV/CC INDICATOR [17] is in red color, adjust the CH1 CURRENT TUNE KNOB [19] to give a

suitable current.

7. To setting CH2 voltage, repeat the above steps use CH2 VOLTAGE TUNE KNOB [5], short MAIN TERMINAL

[26, 27] and CH2 CV/CC INDICATOR [6] instead.

Remarks:

1. If CH2 cannot be adjusted, check the TRACKING MODE SELECTION KEY [12, 15] is not pressed.

2. If want to preset a desired current output before connecting to the circuit, read Section 5.2 first.

Caution:

Make sure the INPUT VOLTAGE SELECTOR [33] set to a correct position Otherwise; it will damage the

power supply.

Do not short the MAIN TERMINALS over 1 minute; it will damage the power supply.

5. POWER SUPPLY DESCRIPTION