aero-naut Princess 사용 설명서 - 페이지 11
{카테고리_이름} aero-naut Princess에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aero-naut Princess 17 페이지. 3081/00
페이지 인쇄
42
45
37
32
48
48
13
44
43
2
37
41
46
2
32
47
47
33
Glue together the two parts 44 at the
tabbed joints to form the back panel, and
press this assembly against the top edge of
frame 2 between the side panels 37. Do
not glue it to frame 2! Glue the partition
wall 42 to the couch floor 41 and to the
side panels 37, keeping the panel vertical.
Glue the cladding 43 to the partition wall
42.
34
Glue the side support rails 45 to the outside
of the side panels 37, after masking off the
deck 32 with adhesive tape to avoid the
rails becoming stuck to it. The rails 45
should end flush with the side panels 37 at
the front, and project by 5 mm at frame 2.
Trim the rear support rails 46 (see next
stage) to fit between the side rails 45.
Leave all the glued joints to set hard, then
carefully remove the cockpit cradle from the
hull before applying more glue to the
corners from the underside.
35
Glue the rear support rails 46 to frame 2
and the deck 32 from the rear.
36
Glue the battery support rails 47 to the
bottom of frames 1 - 7. Glue the RC
installation plates 48 to the fore-and-aft
bearers 13 between frames 5 and 6.