Aktakom ACT-1210 사용자 설명서 - 페이지 2

{카테고리_이름} Aktakom ACT-1210에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ACT-1210 4 페이지. 3 in 1 stud/metal/ac voltage finder with laser line level

페이지 인쇄

Features and Benefits

● Stud/Metal/AC wire detection

● Wood, metal and live wire detection-detects wood up to 3/4" depth

● Locate with audio LCD indication

● Normal scan 3/4" & deep scan 1-1/2" selection

● 180" pivoting laser plane with level and plumb vials

● LCD sensing and mode display with new target graphics

● LED display with continuous live wire detection

● 20 foot laser line projection

● Thumb dial adjustable feet for leveling the laser

● Vertical and horizontal mounting holes

● Easy key pad operation

● Ergonomically designed for comfort and grip

● Auto power off

● Low battery indication

SAFETY INSTRUCTIONS:

Failure to follow warnings may result in bodily injury.

The following warnings must be followed to avoid injury:

• DO NOT remove warning labels.

• DO NOT use optical tools such as a transit to

view laser beam. Serious eye injury could result.

• DO NOT project the laser beam directly into the

eyes of others.

• DO NOT stare directly at the laser beam.

• DO NOT project laser beam onto a reflective

surface.

• DO NOT operate around children, or allow

children to operate.

• DO NOT disassemble the laser.

• Always turn off laser when the tool is not in use.

Uon

IMPORTANT:

Read all instructions prior to operating the unit and DO NOT remove any labels from the tool.

The unit produces a straight line on the same surface on which the tool is placed. Any reflection of the line on

another surface should be considered reference.

Introduction



The unit uses electronic signals to locate the position of studs, joists or live AC wires through dry wall and

other common wall materials. Once the edge of the stud has been detected,

the unit LCD display gives visual and audio indications that allow you to easily pinpoint the stud's edge

position. A pencil line allows you to quickly note the location of the stud edges.



The unit generates a laser plane vertically and pivoting 90 degree clockwise or counterclockwise to

generate a laser straight line.



The unit allows the user to locate wood and metal studs up to 3/4 inch for metal and wood stud.



The unit provides automatic calibration for metal and wood stud modes, auto shut off and heavy duty

ABS construction.



Detection mode is selected by keypad function – metal and wood stud. Default mode is wood stud

detection. Mode should be selected before "on" key is pressed.