Aktakom AM-2002 운영 매뉴얼 - 페이지 8

{카테고리_이름} Aktakom AM-2002에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom AM-2002 12 페이지. Insulation tester

4. PRECAUTION & PREPARATIONS

FOR MEASUREMENTS

1. Remove the power from the circuit when making the

measurement. If any voltage is present in the testing

circuit, then an erroneous reading will result.

2. Ensure that the batteries (6 x 1.5 V AA battery) is

connected correctly the right position into the battery

compartment.

3. Rotate the "Function/Range Switch" (3-2, Fig. 1) to the

right position before making measurement.

4. Slide the "Power Lock/Manual(off) Switch" (3-3, Fig. 1)

to the off position if the meter not be used.

1. Connect the RED test plug into "ohm terminal"(3-5,

Fig. 1)

Connect the BLACK test plug into "COM terminal"(3-5,

Fig. 1)

3. Rotate the "Function/Range Switch"(3-2, Fig. 1) to the

"200 OHM" position.

4. Connect test alligator clips into circuit under test.

Push the "Test Button"(3-4, Fig. 1) for measurement.

Remark :

A continuity beeper is equipped. If the measured resistance

< approx. 50 ohm, the beeper sounds will be generated.

Do not apply the external voltage

to the input terminals !