Aktiv X3 매뉴얼 - 페이지 5

{카테고리_이름} Aktiv X3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktiv X3 16 페이지. X series

1.3 SUITABLE OPERATIONAL CONDITIONS

The wheelchair you have purchased is suitable for use indoors or outdoors, in smooth to moderate terrain.

It is not recommended for use over rough terrain, loose gravel or soft sand. The wheelchair should never be

immersed in water or be exposed to salt water or other corrosive materials. Clean your wheelchair thoroughly

after use in rainy or wet conditions to avoid corrosion.

This wheelchair can be adjusted to fit a range of body shapes and sizes. Specific adjustments to the wheelchairs

components will be shown throughout this booklet. Optional accessories and can be fitted to all Aktiv chairs to

accommodate a wide variety of disabilities comfortably. Always consult with a trained health care professional

to find which adjustments are required to make your wheelchair suit you best.

1. To remove or attach the rear quick release wheels press the detent release button on the axle with your

thumb and pull to remove or push to attach. (ref. fig. 6)

2. Some wheelchair models are supplied with a separate seat cushion and backrest padding. They are simply

attached by velcro. Once the wheelchair is open, place the seat cushion and backrest padding on the chair so the

velcro sections attach to each other or so that the non slip surface is placed downwards against the sling.

3. Attach the footrest hangers by sliding it into the frame from the outside and then swinging it towards the front

allowing the catch to hold the footrest in place securely. Flip footrest down for feet to rest upon. (ref. fig. 6) To remove

pull the release lever on the footrest hanger and swing to the outside of the chair. Lift the hanger off the frame.

Designed to t

user height range

1470mm -1880mm

Fig. 6

MAX. USER

WEIGHT

130kg

50cm seat: 440mm-490mm

45cm seat: 410mm-440mm

40cm seat: 340mm-360mm

Fig. 4

loosen

tighten

Fig. 7

Press quick release button

to install/remove rear wheel