AeroAudio HP AMP AES67 TM 매뉴얼 - 페이지 2
{카테고리_이름} AeroAudio HP AMP AES67 TM에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AeroAudio HP AMP AES67 TM 9 페이지.
페이지 인쇄
Dante™ controller
software
HP AMP AES67 TM
MANUAL
Network setup
By default the HP-AMP-AES67 is shipped with DHCP on. Without a DHCP server in
the network, the AMP can be found using the Dante™ controller software. You can
use a direct cable connection between the computer and the AMP. Although a switch
can be used, it is not needed. The latest version of the Dante™ controller software
can be downloaded from the official Audinate website at https://www.audinate.com.
Within the controller software you will find the AMP using the "device info" section.
By double clicking the device (in red) you will find the IP range of the AMP.
To change setting on the AMP you will need to match the IP address of the
computer to the range of the AMP. In this case 169.254.81.xxx
STEENWEG 148C - 9810 NAZARETH - BELGIUM - T +32 (0)9 396 76 40 - [email protected]