Aktobis WDH-H600A 운영 매뉴얼 - 페이지 6
{카테고리_이름} Aktobis WDH-H600A에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktobis WDH-H600A 11 페이지.
2.) Preparation and installation of the filters
The air purifier is equipped from the factory with a pre-filter as well as a HEPA filter, an active carbon filter and an
EPA & active carbon filter combination. First open the two latches of the air purifier by pressing them and pulling
them outwards. Now remove each individual shelf of the air purifier piece by piece to access the individual filters.
Be careful to pull the motor shelf a little harder and straight upwards, as it is connected to the lowest shelf by a plug
(see fig. 1 & fig. 2). When inserting the combi-filter, make sure that it is inserted the right way round. Also, when
reassembling the unit, make sure that the shelves are attached in the correct order and correctly aligned. It is
important that the electronic contacts of the top shelf connect with the contacts of the caps (see fig. 3 & fig. 4). The
same applies to the plug connection of the lowest tier with the motor (see fig. 1 & fig.2) !
Note: If the shelves or the air purifier are assembled incorrectly, the air purifier will not switch on because there is
no power supply !
Fig.1
Fig.2
Fig.3
Fig.4
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: [email protected]