AeroBed R2110 AU / RDV 사용 설명서 - 페이지 5

{카테고리_이름} AeroBed R2110 AU / RDV에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AeroBed R2110 AU / RDV 8 페이지.

This is the closed position.

4. Plug into any standard polarized 240 Volt AC electrical outlet.

This product electrical rating: 230 VAC, 50 Hz, 0.55 A.

Note: Because this is an electric device,

ensure your hands are dry when connecting

the cord set to the pump or plugging it into

the wall outlet.

5. Turn dial on pump to "Inflate" position. Bed will inflate hands-

free. When desired firmness is reached, turn dial to neutral

position (Off).

6. To adjust firmness level, slowly turn dial on pump to silent

adjust position (see figure Adjust). Pump will slowly release

air. Turn dial to neutral position once you reach your desired

firmness level. To add more air, repeat Step 5.

IMPORTANT: PUMP HAS RESETTABLE FUSE

WITH AUTO SHUT-OFF FEATURE. IF PUMP

RUNS FOR APPROXIMATELY 5 CONSECUTIVE

MINUTES, THE AUTO SHUT-OFF FEATURE WILL

ENGAGE WHICH WILL ALLOW THE MOTOR TO

COOL. PUMP WILL AUTOMATICALLY RESET

ITSELF IN APPROXIMATELY 30 MINUTES.

Make sure product is completely dry and clean before deflating and storing.

1. To deflate your AeroBed

2. For most compact storage, close Quick Release Valve, plug

power and turn dial to Deflate. Once excess air is released, turn

dial to neutral position (Off).

3. Roll or fold the AC cord and secure it. Fold sides of bed into the

center along its length. Tightly roll and place bed in convenient

carry bag for easy storage and transport.

4. Store your bed in a clean, dry place at room temperature

(above 50 °F / 10 °C). Storing your bed under 50 °F (10 °C) and

over 100 °F (38 °C) may affect its performance and will not be

covered under warranty.

Open Quick Release Valve.

DEFLATION AND STORAGE

product, open the Quick Release Valve.

Close valve using 2 thumbs.

Adjust