Aerobits TR-1F 매뉴얼 - 페이지 4

{카테고리_이름} Aerobits TR-1F에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerobits TR-1F 7 페이지. 0.25/0.5/1 watt ads­b and flarm transceiver

페이지 인쇄
www.aerobits.pl
Connector
Main
Installed on board
Mating connector
Antenna
Installed on board
Mating connector
Table 4: Mechanical parameters
QUICK START WITH TR­1F
TR­1F is a stand­alone device and in the simplest case of its operation requires only a power supply. However during the first
start­up, you must configure the device. That can be performed in the few steps described below. First install the antennas using
the MCX­> SMA adapters included in the kit. Also connect the configuration cable that will help you set the device parameters.
The following figure shows the installation method.
Figure 2: Combination overview
1. Connect the device to the PC. The converter is supplied with the FTDI chip. In this case, the installation of the controller
takes place automatically.
2. Download the latest Micro ADS­B software from www.aerobits.pl. Install Micro ADS­B on your Windows computer. If
the device is connected to a PC, it should be found automatically after clicking the "Connect" button. The connection window
should look similar to the one in the picture.
Select the device found and press "OK".
Revision: 09­March­20
This document is subject to change without notice. For technical questions, contact:
Type
Example
BULGIN, PXMBNI05RPM04APC
BULGIN, PXPPVC05FBF04ACL010PVC
MOLEX, 73415­1061
MOLEX, 73366­0010
4
TR­1F
ADS­B In/Out
Document Number: 090320