American Recorder AllCast MULTI-FUNCTION MONITOR STAND 매뉴얼 - 페이지 6
{카테고리_이름} American Recorder AllCast MULTI-FUNCTION MONITOR STAND에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Recorder AllCast MULTI-FUNCTION MONITOR STAND 8 페이지.
페이지 인쇄IMPORTANT NOTE: The ALLCAST Multi-Functional Monitor Stand can be used with either a single or dual
flat screen monitors. This stand will not support three monitors.
STEP 6
STEP 6a SINGLE MONITOR- Place monitor arm onto pole and
secure by tightening arm support bolt with Allen Wrench Key.
MONITOR ARM
STEP 6b -Select Monitor bolts and spacers
Most computer monitors 27" or
under use a 4mm bolt for attaching
the VESA Plate.
Bolt length: Verify adequate threat engagement with bolts or bolts/spacers combination. We
recommend thread engagement of at least 5 full turns. Too short and bolts will not safely hold
the monitor. Using bolts too long may damage the monitor.
STEP 6e -Hang monitor(s) to the stand and secure with Thumb Bolt
ALLCAST MULTI STAND OWNERS MANUAL ver2.0
Saturday, February 20, 2021 3:05:55 PM
Monitor Arm Assembly
or
ARM
SUPPORT
BOLT
THUMB BOLT
6
STEP 6a DUAL MONITOR- Place DUAL MONITOR ARM onto pole
and secure by tightening arm support bolt with 6mm Allen Wrench Key.
DUAL MONITOR ARM
STEP 6c - Attach the VESA PLATE to monitor
FLAT BACK
MONITOR
PANELS
CURVED BACK
MONITOR
PANELS
STEP 6e -Tighten TENSION SCREW with 3mm Allen Wrench Key so
the monitor angle can be easily adjusted by hand, but enough
pressure to stay in place.
TENSION
ADJUSTMENT
SCREW
ARM
SUPPORT
BOLT
M4 Bolt
Washer
or
M4 Bolt
Washer
Spacer
M4 Bolt
Washer
Spacer
100
95
75
25
5
0