American Rotary AD 60 작동 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} American Rotary AD 60에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Rotary AD 60 15 페이지. Adx-cul cnc/heavy duty rotary phase converters

페이지 인쇄

1. INTRODUCTION

American Rotary specializes in converting Single Phase electrical power to Three Phase electrical

power. The diagram below provides a very simple view of the layout.

An additional 3-phase breaker panel may be installed on the line between the converter control

panel and the 3-phase equipment. This is recommended to protect each piece of equipment and

the wire that feeds that equipment.

The two single phase lines pass through the phase converter and are used to manufacture the 3

line that completes the three phases. The output voltage will always be close to the input voltage.

If a completely different voltage is needed, then a transformer installed in front of the phase

converter will be necessary.

The three-phase output is delta configured. This means that voltage measurements between

phases will be similar to input voltages. Voltages should only be measured line to line. Do not

measure voltages line to ground. Most machinery requires a delta three phase voltage and this

third line voltage to ground should not affect operation. If a piece of equipment requires wye voltage

and a neutral connection, the output of the phase converter must be run through a delta-wye

transformer to create the neutral. The phase converter must be started before the transformer is

connected electrically. This is done with a safety disconnect switch. American Rotary can provide

these transformers and disconnect switches.

Three phase generator (idler)